|
|
Joined:
July 2003
Posts: 35
Location: Canton,GA | Hey I am back and although I had to change my user name I think I was hendoandson and for some reason I have lost my password anyway I am finally getting ready to build my Deaconstrat
it is a sunburst Deacon with the shaller tailpiece and I am putting in 3 EMG S pickups for noise free performance I wish patterned my pickguard a little smaller but the big one might be okay anyway I will let you al here know when its ready and see if you can offer any pointers on where to put the input jack since I do not want it on the pickguard any advice would be greatly appreciated!!!!!!!!!!!!!!!!Samova EMail
me some time at hendoandson@alltel.net |
|
| |
|
Joined:
January 2003
Posts: 1498
Location: San Bernardino, California | http://www.ovationfanclub.com/gallery/Manual_Footnote.JPG
Take a look at where the jack is on the older Breadwinners. You could probably bend a flat jackplate to get it to fit. Or maybe one of those extended reach panel jacks, if you're not using active electronics. |
|
| |
|
Joined:
March 2002
Posts: 15683
Location: SoCal | Take a look at this place for jack plates.
http://www.guitarpartsresource.com/hardware.htm |
|
| |
|
Joined:
May 2002
Posts: 3005
Location: Las Cruces, NM | Do your best kid, us solid body freaks will be with you all the way. Whatever you come up with, let us know how it plays. Viper power forever (or at least to the Inn at the End Of The Universe) Sorry, we haven't had much solid body red meat in quite a while. |
|
| |
hey I am back finally AKA hendoandson