|
|
Joined:
December 2009
Posts: 6
Location: California | I need a pot volume control for the pro preamp 2009
do you have one???? :rolleyes: |
|
| |
|
Joined:
December 2003
Posts: 13996
Location: Upper Left USA | On the OP Pro Preamp?
I think it's easier and less time consuming to just replace the preamp.
Or is it the knob that's broken?
And Welcome!
 |
|
| |
|
Joined:
December 2009
Posts: 6
Location: California | Hi thanks for answering. No the pot is broken i have tested it with a ohm meter needs a new one ,
I sure not going to pay for a new one when all it needs is a new pot i can solder one on in five minutes. so do you know where i get that replacement pot?? t i a Cap. |
|
| |
|
Joined:
December 2003
Posts: 13996
Location: Upper Left USA | I would then contact Customer Service and ask what the specs are on the potentiometer and try www.mouser.com for a replacement.
If you pull the Pot it may have the spec written on itself. |
|
| |
|
Joined:
December 2009
Posts: 6
Location: California | Hi MWoody, Yea this darne thing pot has a special metal bracket built into it that fits the circuit board exactly just finding the value of the pot would not work. good ebay page Cap. |
|
| |
|
Joined:
October 2005
Posts: 4075
Location: Utah | Is it out of warranty? If you're the original owner, it should be covered. |
|
| |
|
Joined:
December 2009
Posts: 6
Location: California | Problem resolved sent to place of purchase for replacement. thanks for all your help!!! Cap. |
|
| |
|
Joined:
December 2003
Posts: 13996
Location: Upper Left USA | Hmmmm, brought back to place of purchase for warranty...
Alpep, I love you man! |
|
| |
Need part for Ovation pro preamp
