|
|
Joined:
November 2002
Posts: 3599
Location: Pacific Northwest Inland Empire | Made the heavyweight division, too, at 10-1/2 lbs!
Probably not goin' buskin' with this porker.
Next project (probably) is the case........with wheels..........motorized.........turbohydromatic tranny............air-shocks..........backup alarm |
|
| |
|
Joined:
April 2008
Posts: 2985
Location: Sydney, Australia | That turned out really nice. Well done. Be interesting to hear how it sounds. |
|
| |
|
Joined:
November 2002
Posts: 3599
Location: Pacific Northwest Inland Empire | Thanks!
If I can ever figure out how to post a sound sample, and get someone competent to play it...........it truly has a BIG voice. |
|
| |
|
Joined:
November 2002
Posts: 3599
Location: Pacific Northwest Inland Empire | OK, so this is what happened to the Rogue carcass. I just couldn't throw it out. So, I glued all the neck cracks back together, laboriously carved the square neck into a round one, replaced the plywood top with a cedar version, with an inlaid rosette, used an Ovation bridge & ganged-up 3 saddles to fit the hole where a wide-bottom sensor SHOULD have gone, and pasted the whole mess together.
I included the side-by-side with the REZXII, as the Rogue was the hardware donor for the 12-string project. I can imagine hearing the redone Rogue using Danny Devito's line from the movie "Twins", "You mean, I'm the crap?!"
 |
|
| |
|
Joined:
December 2003
Posts: 13983
Location: Upper Left USA | As I know we both agree that the Journey is the best part I commend you for your efforts!
Another Box/Bowl saved is a worthy prize in of itself.
The fact that it is a playable piece of craftsmanship is awesome as well.
Do you need a little piece of Koa to um... extend that Bridge a bit or is that where the Abalone goes?
 |
|
| |
|
Joined:
November 2002
Posts: 3599
Location: Pacific Northwest Inland Empire | Hmmmm...........abalone.
Might be "gilding the lily" a bit, or perhaps putting lipstick on a pig, but whaddya got in mind, in terms of extending the bridge? Wider, or longer? I've got a couple of hand-built FET preamps, so I could make it A/E, and make some bolsters for a thinline piezo.
I'm waiting to see if the the critter handles the stress for a few months. Leveling the frets on a bar-slide instrument was some effort. A good & level fret installation was apparently not a high priority in its manufacture. |
|
| |
Evil Thoughts
