The Ovation Fan Club
The Ovation Fan Club
Forum Search | Statistics | User Listing Forums | Calendars | Albums | Language
Your are viewing as a Guest. ( logon | register )

Random quote: "There are more love songs than anything else. If songs could make you do something we'd all love one another." -Frank Zappa



Jump to page : 1
Now viewing page 1 [25 messages per page]
Restoration of Surface

View previous thread :: View next thread
   Member Communities -> Bottom Feeding Luthiery GuildMessage format
 
prsnalrctr
Posted 2013-04-17 8:43 AM (#469638)
Subject: Restoration of Surface


Joined:
April 2013
Posts: 2

Location: Cincinnati, Ohio


Joined:
April 2013
Posts: 1

Location: Cincinnati, Ohio I am new to Ovation. I have really liked them through the years and finally started playing again after a break of about 25 years. I have bought 3 Ovations. 1 Celebrity, 1 Glen Campbell, and one that dates back to 1979 with an aluminum frets. My question is the body on all of them is very sound, but the surface needs to be redone. I contacted Ovation and they said that all of their guitars are coated with Polyurethane. What is the best way to remove the coating without using chemical that would break the bond in the glue that holds the tops and bridges. I know sanding would be ok but would take forever. But if that is what I have to do that is ok, I have done it before. Are there any suggestions. Good to find a forum that specializes in Ovation guitars and people who enjoy them.
Top of the page Bottom of the page
MWoody
Posted 2013-04-17 11:24 AM (#469639 - in reply to #469638)
Subject: Re: Restoration of Surface



Joined:
December 2003
Posts: 13983

Location: Upper Left USA
Polyurethane is pretty much permanent unless removed by grit or chemicals, the same chemicals that will disintegrate the Bindings.

At the factory they pull the bridge and soundhole ring or epis and sand off the top on the 12 foot long sander.

When you renish use Lacquer so you can re-touch later!
Top of the page Bottom of the page
SOBeach
Posted 2013-04-20 12:53 PM (#469700 - in reply to #469639)
Subject: Re: Restoration of Surface


Joined:
April 2010
Posts: 823

Location: sitting at my computer

MWoody - .. the same chemicals that will disintegrate the Bindings.

well then, I guess trying a little stripper is out.... unless she'll help ya sand the guitar!  Bahdum Tsssssh 

 

Perhaps a heat-gun might be helpful?

 

Stewmac.com

http://www.stewmac.com/tsarchive/ts0151.html

 

SemourDuncan.com   (heat-gun NOT hair-dryer)

http://www.seymourduncan.com/forum/showthread.php?235376-How-do-I-remove-my-guitar-s-Poly-Finish

 

Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

This message board and website is not sponsored or affiliated with Ovation® Guitars in any way.
Registered to: The Ovation Fanclubâ„¢ Copyright (c) 2001
free counters
(Delete all cookies set by this site)